Download warning

2-6 Performing Cutting
To Perform Cutting
To perform cutting, carry out the procedure described below.
➢Move the media clamps to locations where they don’t clamp the media. Alternatively, remove the
media clamps.
Media clamps
➢When you're performing cutting only, then if you're cutting roll media, allow the media to hang
down from the rear of the machine.
If cutting is started without doing this first, a motor error may occur or the roll may fall because the media is
pulled with excessive force.
Turn the media flanges by hand to
pull out the necessary length from
the roll.
Important Notes on Cutting
➢Never use the media clamps.You can also detach them when not in use.
☞ P. 81, "Printing Media That Warps Easily"
➢When you’re performing printing followed immediately by cutting, then before you start cutting, allow the ink
to dry sufficiently. Use your software RIP to make the setting for the drying time. For information on how to
make the setting, refer to the documentation for the software RIP you're using.The drying time varies according to the media.
Chapter 2 Operation
45