Download BME 4910 Operator`s Manual

The connection of the outriggers to the Plexiglas ski is shown in Figure 35. Tube adapter is
inserted into the outriggers and screwed onto the Plexiglas with three ½ in #10 pan head
screws. The finished outrigger is shown in Figure 8.
Figure 35: The connection of the outriggers on the Plexiglas skis
3.2.5 Corner braces
Four corner braces are used on the device, two 1” x 10” x 3/16” and two 1” x 8” x 3/16”.
Each pair of the corner braces is bent to the same angle so that it can provide support to the
armrests and back support. One end of the corner brace is welded to the main structure and
the other end is screwed in the reinforcement bars and skis using 1 in. #10 pan headed screws.
The corner brace is shown in Figure 36.
Figure 36: Corner Brace
3.4 Saddle Eating Chair
Base frame is made from 2”x2” aluminum square tubing. The front is the widest section
it is 16 ½” the middle piece is 15” and the back is 14 1/2”. It is pictured below
42