Download X0Trail Service Manual

6
Apply Avid DOT Grease to the threads of a new hose barb, the
compression fitting outer surfaces and compression nut threads.
While holding the hose firmly, use a T10 TORX® to thread the hose
barb into the end of the hose until it is flush.
Slide a new compression fitting over the end of the hose with the
new hose barb.
7
23
Push the hose firmly into the lever until it stops.
While holding the hose in place, slide the compression fitting and
compression nut up to the lever or hose stop.
HOSE LENGTH ADJUSTMENT