Download User Manual

Transcript
connected using a specialist photovoltaic electric cable as the DC
cable.
Caution!
 Regarding the inverter equipped with DC switch, please ensure the
switch is in "OFF" position before connecting the inverter with PV
panels. Then switch to "ON" when finished connecting job.
 Before connecting the PV panels, please ensure the plug
connectors have the correct polarity. Incorrect polarity connection
could permanently damage the unit.
 Checks short-circuit current of the PV string. The total short-circuit
current of the PV string cannot exceed the inverter’s maximum DC
current.
 High voltage exists when the PV panel is exposed to the sun.
Please secure the terminal connection, and do NOT touch any
exposed components in case of electric shock.
 If you choose the models without DC switch an external
disconnection device should be used. It should be multi-pole
switch-disconnector (all poles disconnected simultaneously), which
has been approved according to standard IEC/EN 60947-3. The
rated current should be between 20A and 25A.
3.4.3 RS485 Communication
RS485 interface is used for multipoint communication. EzLogger
can monitor and communicate with 50 inverters at the same time.
18 / 56