Download User manual

11.0 Handle Schematic Drawing
4.0 Operating Tips Continued
•
For indoor use only. Sweep abrasive soils before scrubbing.
•
While the brush or pad driver is spinning, keep the floor
machine moving to avoid “donut” burns on the floor.
To Start Operation Continued:
•
Squeeze the dual triggers to release power to the motor. Once
power is on, either trigger will keep power to the motor.
•
To stop the BISSELL BigGreen Commercial Lo-Boy Floor
Machine, release both triggers.
4.1
To Store your Machine
•
Lock the handle in the “up” position. Wind the cable around
the handles and the bottom cable hook.
•
Tilt the machine back and remove the pad driver or brush using
a BISSELL Big Green Commercial locking tool. Never store
the floor machine standing on the brush.
•
Wash brushes or pads and hang to dry. Never store machine
standing on the brush.
•
Check and clean pads after each operation.
Remove soil and chemical buildup. Replace
worn or damaged pads.
•
Check the triggers and switches for proper
operation.
•
Repair or replace damaged skirts and dumpers.
•
Use air pressure or vacuum to remove dust and debris from the motor vents.
•
Inspect and maintain equipment on a regular schedule for best results. Report
problems and repair promptly.
4.2
Transport
To transport this floor machine from the janitor’s closet to the work area:
•
Lock the handle in the “up” position. Wid the cord around the handles and the
bottom cord hook.
•
Tip the machine back onto the transport wheels. Push or pull the machine by the
handle, not by the cord or any other part of the machine. Travel carefully.
SALES | SERVICE | PARTS
1-877-977-3339
JanitorialEquipmentSupply.com
(16) BISSELL Lo-Boy BGLB9000 - Orbiting Floor Machine
BISSELL Lo-Boy BGLB9000 - Orbiting Floor Machine (9)