Download Important notes

System expansions
Removing the module holder
• Requirement: open the casing (see "Opening the casing", Page 33).
► Disconnect the cables connected to the module holder.
1
1
2
2
3
► Remove the screws (1) on the module holder.
► Push the module holder a few centimetres out of the casing in the direction of the arrow (2).
► Pull the module holder completely out of the casing in the direction of the arrow (3).
Screwing the reader onto the module holder
► With the component side facing downwards,
slide the reader in the direction of arrow (1)
into the guide on the module holder (a).
► Fasten the reader with the screws (2).
2
2
a
a
Fujitsu
1
43