Download VT592 User Manual
Transcript
VT592 User Manual VT-ENG-592-V1 1005S24 1. Parts and Functions Camera Lens Speaker 176 mm Night View LED Nameplate A Call Button B Call Button Microphone Rainy Cover 90 mm 23 mm 2. Terminal Descriptions MIC adjustment SPK adjustment •• •• •• •• •• Monitor A 1R (Red): Power positive. +12V present when Door Station calling or being monitored. 2W (White): Power negative (Ground). 3Y (Yellow): Image signal (Video signal). 4B (Black): Talk and control signal (Audio signal). LK+,LK-:Normally opened connection port. -1- LK- 1R 2W 3Y 4B Monitor B LK+ 1R 2W 3Y 4B Connection Port 3. Mounting 3.1 Mounting Without Rainy Cover 1 2 3 4 3 4 1 2 160-165cm 3.2 Mounting With Rainy Cover 1 2 1 2 160-165cm -2- 3.3 Adjusting Camera Angle use a screwdriver to loosen the screw and then adjust the angle of the camera ,then fix the screw. 4. System Wiring and Connections 4.1 Basic Connection VT592 Door Camera To Monitor A JS_OS1 LK- LK+ 1R 2W 3Y 4B 1R 2W 3Y 4B Back View Control Monitor A -3- Black White Red To Monitor B JS_OS1 Yellow Black Yellow Red White Control Monitor B 4.2 Electric Lock Connection •• Mode1:Door Lock Controlled With Dry Contact Must install external power supply for lock,and nearly all kinds of electronic lock can be used. Incidentally,in this mode,you can continue talking and monitoring during unlock operation. Note: 1.The external power supply must be used according to the lock. 2.The inside relay contact is restricted to AC or DC 24V/3A. POWER SUPPLY 1 2 LKLK+ + - •• Mode2:Door Lock Controlled With Internal Power LKLK+ The lock can be directly connected with the door station and the power through monitor.During unlock operation,the monitor will close screen automatically. Note: 1.Electronic lock of power-on-tounlock shoule be used. 2.The door lock is limited to 12V,and holding current must be less than 250mA 1 2 Connect with 1R Connect with 2W - + 5. Specifications Power Supply: Consumption: Video Output: Camera: Working temperature: DC 10~12V (Internal Power supply) 200mA in working state (latch not included) 75Ohm, 1Vp-p, CCIR standard (unless specified) 76 degree, CCD camera with IR-LED -10ºC ~ 40ºC -4-