Download Corix 70 PRO

9.0 CONTROL PANEL OPERATING INSTRUCTIONS
The Control Panel Unit includes the “Power Control Stage” and the “Timer
Control Stage”. The purpose of the “Power Stage” is to supply the Main Voltage
to the Tubehead. The “Timer Stage” controls the exposure timing. The Timer is
built around a microcontroller IC which contains preset exposure times and Main
Supply voltage variation algorithm compensations. By means of four keys, the
user is able to select pre-programmed exposure times or manual exposure times.
The Control Panel contains an LCD Graphic Display which allows the user to
operate the timer.
Main Switch:
F1 Key:
F2 Key:
Up Key (▲):
Down Key (▼):
LCD Display:
Hand
Controller:
When turning this switch on, the unit is
energized.
Multifunction key.
Multifunction key.
By pressing this key, it is possible to increase
the exposure time, in the manual exposure
mode.
By pressing this key, it is possible to decrease
the exposure time, in the manual exposure
mode.
The display shows to the user, relevant
information about the Control Panel operation.
By pressing the Hand Controller button, the
exposure radiation will start.
34
Corix PRO 70
Installation & User´s Manual