Download User Manual WIB3S

Transcript
The WIB3S can be integrated to the board connecting block. For receiving and saving
messages in spite of the board network is switched off, the WIB3S must be connected
directly to the battery. Additionally the supply lines must be protected by a fuse directly at
battery.
With the enclosed USB cable the connection of the WIB3S (outlet USB) with PC/Notebook
will be done.
The bulk of the USB jack as well as the connection 12V(-) are coupled with each
other. Please note: you can get undesirable ground-loops between the USB
connection and the PC. In such a case other electric devices can be parasetical
connected with ground (or battery -). Devices needing much current could cause a
damage in wiring or connected devices.
Handling
The WIB3S is handled by five keys. Press the power key ( ) to switch the device on or
off. In order to switch off, the power key must be pressed during approx. 3 seconds.
Use the four cursor keys (▲▼◄►) to navigate within the menus. After switch on, the
WIB3S displays the main menu (see figure below).
On the left beside the menu entries an arrow is located which can be moved by the keys
▲ and ▼.
With the key ► the menu entry beside the arrow is selected. With the key ◄ the previous
menu step can be reached until the main base. Practice a while with the handling of the
cursor keys, until you are familar.
On top of the display the actual air pressure, the air pressure tendency and the time of day
are displayed. If the WIB3S is in timer operation the remaining term is also shown.
The menu language of the WIB3S can be changed (see section Language, page 15).
5