Download Sunny Beam Manual.book

Sunny Beam Manual
Installation and Setup
NOTE: To operate effectively, the PG connector for the antenna must be grounded.
It is important that the metal of the PG connector make good contact with the metal
case of the inverter. Make sure that the teeth of the locknut face the metal and that
the locknut is tightened sufficiently to allow good metal to metal contact.
• Thread the locknut onto the pressure screw and tighten.
• Once the antenna is in place, thread the coax connector onto the Radio Piggy-Back
board. Tighten until snug - do not over tighten.
• Check the DIP switch to make sure that it was not changed accidentally during installation.
• Verify that the coax is routed through the inverter safely.
• Replace the inverter cover.
%.3
%.3
3
3
3
3
3
3
6
6
0'CABLEGLAND
COAXIALCABLE
ANTENNA
Figure 1-6 Mounting the Antenna to the Inverter
7