Download Messages and Codes - ServiceNet - T

rvsMVS Messages and Codes
5. rvs Messages
the people who are responsible for the local rvs installation. The file cannot be received until
the exit DFUX001 has been changed.
DF3736E
*R-sid* text
This message precedes the message DF3525W. 'text' is a message which is passed to rvs
by the user exit.
DF3738E
*R-sid mn* RECEIVING OF dsname REJECTED, DUPLICATE FILE
The data set "dsname" shall be received from station "sid". During start of this transmission
rvs detected, that
•
•
•
•
DF3739E
the file to be received is to be cataloged after reception,
a cataloged data set with the same name is already existing (if the rename function is
used, the data set with the new name (not with name "dsname") is already existing),
the GDG function for this file has not been specified,
a replace request for this file has not been specified. As a result of these conditions,
receiving of this file will be rejected.
*R-sid* EXTENSION OF dsname FAILED
The data set "dsname" is to be received from station "sid". For the reception of the file the
replace function is active, this means an already existing data set with this name is to be
replaced by the new data set (for example the replace parameter has been specified within a
resident receive entry). But the space allocated by the already existing file is not sufficient to
store all data of the new file. In this case rvs tries to extend the already existing file (allocation
of a new file on the same disk with a new name, deletion of the existing file, renaming of the
new file), but the extension failed. As a result of this error, reception of the file will be rejected.
The file can be received only after the already existing file has been extended.
This message is preceded by message DF2701P, which contains more information about the
kind of the error (probably allocation error (not enough space) for the new (extended) file).
DF3742E
*R-sid mn* ESTAE RECOVERY FOR ABEND code, DSN=dsname
A file with the name “dsname” is to be received from station “sid”. An abend “code” has
occurred (e.g. system abend B37 or D37). This abend will be recovered by normally
termination of the transmission. A dump will not be written for the abend.
DF3743P
*R-ORT M0* RESIDENT ENTRY (RR) FOR 12345678901234567890123456 IS USED
Information a resident receive entry is used.
DF3744I
DF3745P
*R-ORT M0**
*R-ORT M0*
text
00010203 04050607 08090A0B 0C0D0E0F
*0123456789ABCDEF*
Messages DF3744I until DF3745P are for error detection only. They are not in effect for users
purpose.
DF4101I
*f-sid mn* dsname, volume, nnnnnn BL, day, time, sid2, JOBNAME=jobname
This message appears as a reply to the commands 'DS', 'DR' or 'DQ'. The contents of some
parameters of this message depends on the type of command entered. The meaning of the
parameters is: