Download 40200H-CT - Cutech Tool LLC

ASSEMBLY
WARNING! MAKE CERTAIN THAT THE MACHINE IS DISCONNECTED FROM THE
POWER SOURCE.
ATTACHING DEPTH ADJUSTMENT HANDLE
1.
2.
Remove the depth adjustment handwheel by loosening the screw
Install the knob on the handwheel by using the provided screw. Then put whole handwheel
assembly over the shaft and tighten. SEE FIG. 1.
ATTACHING DUST PORT
1.
2.
3.
Facing the rear of the machine, locate the dust chute on the cutterhead assembly. Turning
counterclockwise, remove the 3 dust chute knobs. SEE FIG. 2.
Align the dust port over the holes on the top of dust chute and replace the dust chute knobs.
To minimize sawdust accumulation on your workpiece, attach either a 2-1/2 in. or a 4 in.
vacuum hose to the dust port.
FIG. 2
13