Download User Guide and Hardware Maintenance
Transcript
2 System health LED The system health LED helps you to determine if there are any system errors. • Off: The server is off or the server is on and working correctly. • Amber: The server has potential system errors. Check the information in the following table for potential system errors and corresponding solutions. • Blinking: TSM initialization is in progress. Potential system error (system health LED: amber) Solution The temperature of the server reached the non-critical temperature threshold. Check the BMC for errors and check the system fans. The voltage of the server reached the non-critical voltage threshold. Replace the system board. Note: This action must be performed only by Lenovo service personnel. See Chapter 8 “Getting information, help, and service” on page 137. A fan is running at low speed. Check the system fans. A system fan has been removed. 1. Ensure that the system fans are connected securely to the system board. 2. Reinstall the removed fan or install a new fan to replace the removed fan. The power supply has a critical error. Check the BMC for detailed information. A power cord has been disconnected or a redundant power supply has been removed. 1. Ensure that the power supplies are installed securely. 2. Ensure that the power cords are connected securely to the power supplies. 3. Install a new power supply to replace the removed one. The system is overheated. 3 Check the BMC for errors and then check the system fans. Power button with power status LED You can press the power switch to turn on the server when you finish setting up the server. You also can hold the power switch for several seconds to turn off the server if you cannot turn it off from the operating system. See Chapter 4 “Turning on and turning off the server” on page 37. The power status LED helps you to determine the current power status. Description Status Color On Green The server is on. Off None The server is off. Chapter 3. Product overview 19