Download OPERATOR MANUAL - KINZE Manufacturing, Inc.

Lubrication and Maintenance
Grain Cart
M0238-01
Wheel Bearing Replacement
Inner Bearing
Inner Cup Hex Nut
Hub
Spindle
Stub Bolt
Seal
Cotter Pin
Slotted
Nut
Seal
Washer
Dust Cap
Inner Cup
Bolt
NOTE: See “Inside Tire Repair Or Removal” section of this manual for instruction on tire removal/access to
inner wheel hubs on Row Crop carts.
1. Raise tire clear of ground and remove wheel.
2. Remove dust cap attachment hardware and remove cap from wheel hub.
3. Remove cotter pin, axle nut and 2" washer.
4. Slide hub from axle spindle, using a hub puller if necessary.
5. Remove bearings and cups from hub and discard. Thoroughly clean and dry wheel hub.
6. Press in new bearing cups with thickest edges facing in.
7. Pack bearing with heavy duty wheel bearing grease, thoroughly forcing grease between roller cone and bearing
cage. Also fill the space between the bearing cups in the hub with grease.
8. Place inner bearing in hub and press in new grease seal with lip pointing towards bearing.
9. Clean axle spindle and install hub.
10. Install outer bearing, 2" washer and slotted hex nut. Tighten slotted hex nut while rotating the hub until there is some
drag. This ensures that all bearing surfaces are in contact. Back off slotted nut to nearest locking slot and install
cotter pin. Check for endplay in bearings.
11. Fill dust cap half full of wheel bearing grease and install on hub with attachment bolts.
12. Lubricate wheel nuts and install wheel. Remove jack. Torque wheel nuts to 350 ft-lb.
NOTE: Wheel hubs on Kinze grain carts contain high strength ductile iron material. Replace hub with proper
part.
3-28 5/12
TM