Download - Contronics

PROGuard – User’s Manual
Registering
On altering an existing iButtons/TagRF it is possible to change
its description.
To delete a checkpoint, simply select it with the mouse and then
click on 'Delete'.
‘Learn’ Button
When clicked, the button 'learn' enables the Guardus itself to
enter into a learning mode, redefining the current checkpoints or
including new checkpoints. This procedure allows that all of the
programming information, configured in whichever window up to that
moment, be recorded, enabling also that all of the previously registered
checkpoints be, or not, discarded.
For this operation to proceed the data conformation is necessary
as shown in the following window:
If the button 'Yes' is clicked on, new checkpoints can be included,
preserving the current ones. If the 'No' button is clicked on, all existing
points will be discarded thus promoting a full reregistering of
checkpoints. It is also possible to cancel the operation by clicking on
'Cancel'.
The inclusion or reordering of new checkpoints can then be done
by placing Guardus in contact with the communication interface. The
sequence in which the readings are carried out must be the same as
that in which the iButtons are registered.
The reading of a master iButton/TagRF can result in the
Guardus returning to normal operation. Confirmation of the exit of the
learning mode is given through the emission of the signal for rounds
carried out. Guardus will be ready to operate normally, considering the
new checkpoints configuration.
www.contronics.com
69