Download USER`S MANUAL

3. With the help of a second person, carefully tip
the incline trainer down so that the Base (78) is
flat on the floor.
3
Attach a Wheel (77) to each side of the Base
(78) with a 3/8" x 2 1/2" Bolt (4) and a 3/8" Nut
(8) (only one side shown).
8
78
4. Have a second person hold the Left Handrail
(69) near the Yoke (88). Locate the wire tie inside the Yoke. Tie the wire tie around the Left
Pulse Wire (70).
77
4
4
70
Pull the other end of the wire tie until the Left
Pulse Wire (70) is extending from the hole in the
center of the Yoke (88). At the same time, slide
the Left Handrail (69) into the Yoke. Make sure
not to pinch the Left Pulse Wire.
69
Attach the Left Handrail (69) to the Yoke (88)
with two 5/16" x 3/4" Bolts (6); do not fully
tighten the Bolts yet.
Repeat this step with the Right Handrail (75)
and the Right Pulse Wire (71).
88
6
Wire
Ties
75
8
6
71