Download User manual - Psn

Initialize the camera
Use the INITIAL SET switch to reset the settings of the camera to the default.
IMPORTANT:
• The settings including the network settings will be initialized. Note that the preset position settings and the CRT key
(SSL encryption key) used for the HTTPS protocol will not be initialized.
Step 1
Step 5
Pull out the water-resistant cap by following steps 1 - 3 of
the “How to insert an SD memory card” section
(☞ page 18).
Step 2
Move the INITIAL SET switch to the right (ON).
The factory default is OFF.
Move the INITIAL SET switch to the left (OFF).
(Refer to the illustration in Step 2)
IMPORTANT:
• If the Initial set switch is positioned to the “ON” side,
the camera cannot enter the normal operation mode.
Be sure to return the INITIAL SET switch to the “OFF”
position.
Step 6
Return the water-resistant cap and the main sunshield rear
cover to the original state by following steps 5 - 7 of the
“How to insert an SD memory card” section (☞ page 19).
REAR
OPEN
START
LOCK
Step 7
LOCK
Live indicator
Turn on the power of the camera. (☞ page 13: Power
supply)
When the power is supplied, the camera will enter the normal operation mode.
INITIAL SET switch
(OFF⇔ON)
Step 3
Move the INITIAL SET switch to the right, and then turn
on the power of the camera. The camera will start up and
all the settings including the network settings will be initialized. The live indicator will light orange → light off → blink
orange → light orange. The initialization will be complete
when the live indicator lights orange. Before initializing the
settings, it is recommended to write down the settings in
advance.
IMPORTANT:
• Do not turn off the power of the camera during initialization. Otherwise, it may fail to initialize and may
cause malfunction.
Step 4
Turn off the power of the camera.
17