Download ced370 user manual
Transcript
Caution 1 Connector Yellow wire 2 Blue wire 3 4 Orange wire Black wire 5 Red wire 6 Green and green/black wires White and white/black wires Gray and gray/black wires Purple and purple/black wires • Ensure that all loose leads are insulated with electrical tape. 1 2 Cut off the bigger end of the supplied standard connector. Check the car’s wiring carefully, then connect them to the standard connector. 9 8 7 6 1 2 3 4 5 7 8 9 Connect to The +12V car battery which is live at all times. The electric antenna control lead or power supply lead of the antenna booster If there is no electric antenna or antenna booster, or it is manually operated telescopic antenna, it is not necessary to connect this lead. Illumination switch A metal surface of the car First connect the black ground (earth) lead, then connect the yellow and red power supply leads. The +12V power terminal which is live in the accessory (ACC) position of the ignition switch If there is no accessory position, connect to the +12V car battery terminal that is always live. Be sure to connect the black ground (earth) lead to a metal surface of the car first. Left speaker (Rear) Left speaker (Front) Right speaker (Front) Right speaker (Rear) EN 13 English Connect wires: without ISO connectors