Download PDF user manual - SORG Rollstuhltechnik

User Manual Jump
3.7.3 Stabilising Bar (optional)
There are two versions of the stabilising bar: (image
1) Stabilising bar (A) when using standard push
handles. To fold the wheelchair, loosen the star knob
screws (B) on both sides just enough so you can pull
out the stabilising bar on the right side (downwards).
To close after unfolding the wheelchair, move the
guide slot on the right side of the stabilising bar from
the bottom upwards in between back pipe and star
knob screw. Tighten the screw firmly and make sure
the stabilising bar is firm and steady.
(image 2) Stabilising bar (A) with extensible push
handles. To fold and unfold the wheelchair, please
proceed as described above, except for loosening
the eccentric clamp (B) instead of the star knob
screw.
Page 42 of 65
 PLEASE NOTE
Should there be a head rest mounted to the top
of the stabilising bar, you must remove the bar
before folding the wheelchair by removing BOTH
star knob screws/eccentric clamps completely.
Should
PLEASE NOTE
your Jump be equipped with a firm
moulded back, open the stabilising bar before
folding the wheelchair as described above and
then remove the moulded back (as described).