Download Easy Locator

Also connect the power cable to the monitor. Use the standard cable
supplied. See Figure 2.5.
Look for the countersink in the power cable and place it towards the mark
on the connection. Push lightly. If you have it in the correct position it will go
in its position smoothly. To disconnect: Pull out, holding the metal part of
the connection.
Fig. 2.5 Connections on the monitor; to the left, the Ethernet cable and to
the right, the power cable.
Connect the power cable to one of the identical outlets in the battery box
(Figure 2.6). If a RTC is used the power cable is connected to the battery
pack on the RTC, see Chapter Batteries.
2.2.2 Connecting cables to the control unit
Connect Ethernet and power cables to the control unit (Figure 2.6)
Fig. 2.6. The connections to the control unit; left is power and right is
Ethernet communication cable. Above right the connections to the battery
box is seen.
www.malags.com
8