Download User manual

Transcript
Applicable areas:
AIRBUTLER Jordan is designed for use in vehicles with a 12 V connection. Make sure that
Jordan doesn’t affect your visibility.
Start-up:
Open the battery compartment at the rear of the device and fill in 4 required batteries (4 x
AA batteries) and close it. Connect AIRBUTLER Jordan with the 12 V cable to the cigarette
lighter of your vehicle. Fix AIRBUTLER Jordan with the 2 adhesive pads on the dashboard
of your vehicle. Push the „POWER“ button to switch the device ON and OFF. The green
lights indicate that Jordan is working normally. If those lights start blinking, the batteries
are low. When you turn off Jordan the green lights will turn to red and simulate an alarm
system.
Cleaning / Maintenance:
After about 40 hours of duty, AIRBUTLER Jordan should be cleaned. Push the lateral buttons to loosen the device from its bracket. Shift the two locking mechanisms at the bottom of the device to remove the front plate. Clean the metal rings and the two needles
with cotton swabs and cleaning-alcohol.
Further information:
This ioniser purifies air; it is not a substitution of regular airing of rooms. Do not modify the
appliance in any way. Neither the manufacturer nor the trader can accept any responsibility of any kind damage thus resulting.