Download Operating Manual BINDER

WARNING
Contamination of the device with toxic, infectious or radioactive substances.
Danger of intoxication.
Danger of infection.
∅ NEVER take a unit contaminated with toxic substances or sources of infection for recycling according to directive 2002/96/EC.
 Prior to disposal, remove all toxic substances and sources of infection from the unit.
 A unit from which all toxic substances or sources of infection cannot be safely removed
must be considered as “special” waste according to national law. Dispose of it accordingly.
The refrigerants used 404a and R 23 (MKT only) are not inflammable at ambient pressure. They must not
escape into the environment. In Europe, recovery of the refrigerants R404a (GWP 3750) and R23 (GWP
12100) is mandatory according to regulation No. 842/2006/EC. Ensure the compliance with the applicable
legal requirements regarding qualification of staff, disposal, and documentation.
17.5 Disposal of the unit in non-member states of the EC
CAUTION
Alteration of the environment.
 For final decommissioning and disposal of the environmental simulation chamber,
please contact BINDER service.
 Follow the statutory regulations for appropriate, environmentally friendly disposal.
The main board of the environmental simulation chamber includes a lithium cell. Please dispose of it according to national regulations.
The refrigerants used 404a and R 23 (MKT only) are not inflammable at ambient pressure. They must not
escape into the environment. In Europe, recovery of the refrigerants R404a (GWP 3750) and R23 (GWP
12100) is mandatory according to regulation No. 842/2006/EC. Ensure the compliance with the applicable
legal requirements regarding qualification of staff, disposal, and documentation.
18.
Troubleshooting
Fault description
Heating
Chamber without function. Turning on the main power switch (3)
has no effect.
Chamber heating permanently,
set-point not maintained.
Chamber doesn’t heat up.
MK / MKT (E3.1) 10/2013
Possible cause
Required measures
Rear power switch (16) not
turned on.
Turn on the rear power switch (16)
at least one hour before operating
the chamber.
Semiconductor relay defective.
Pt100 sensor defective.
Contact BINDER service.
Controller defective.
Controller not adjusted.
Calibrate and adjust controller.
Heating element defective.
Contact BINDER service.
Semiconductor relay defective
page 68/94