Download Operating Manual - Wolf Laboratories

8.4
Deleting a program section
A program section is deleted from the program by setting the section duration to Zero.
Normal display
for 5 sec.
Press down key
Display 1 shows
Display 2 shows
e.g. 0000
PROGRAM EDITOR
(you are in the program editor)
Hit program key
Display 1 shows
Display 2 shows
0000
UserCod? 0000
(enter user code)
e.g. 0001 (basic setting, adjustable in the user
level, chap. 10).
Value is shown in both displays.
Enter the user code with arrow keys
Automatically forward after 2 sec
Display 1 shows
Display 2 shows
alternating
e.g. 01
--- : --- PRG.
CONTINUE X/W
(program P01 selected)
(program can be selected)
(information: to 1st program section with X/W)
Value is shown in display1.
Select the desired program, e.g. P01, with
arrow keys
Press key
In the selected program P01 or P02, program sections can be selected:
Display 1 shows
Display 2 shows
alternating
e.g. 01
P01: --- SEC.
CONTINUE X/W
(actual selected section: S01)
(program section can be selected)
(information: set-point entry with X/W)
(omitted if section S01 shall be deleted).
Select desired section, e.g. S03, with arrow
keys
Press key
Display 1 shows
Display 2 shows
alternating
e.g. 15.0C
S03:TEMP 15.0
CONTINUE X/W
(actual temperature set-point)
(variable: temperature)
(information: continue with X/W)
No entry
Press key
Display 1 shows
Display 2 shows
alternating
e.g. 02.30
S03:TIME 02:30
CONTINUE X/W
Enter set-point Zero for section length in
hh:mm of S03 with arrow keys
Display 1 shows
Display 2 shows
alternating
e.g. 00.00
S03:TIME 00:00
DELETE SEC. X/W
(actual section length)
(variable: section length)
(information: continue with X/W)
Value is shown in display 2 or in both
displays (display depends on maximum time
setting in the user level chap. 10)
(actual section length)
(variable: section length)
(information: delete section with X/W)
Press key
KB (E3.1) 08/2012
page 34/84