Download User Manual

General
The following general fields should be filled in:
˜ Name - Specifies the name of the Event.
˜ Set Time Interval Between Triggers - The time frame in which a
subsequent trigger of the same event will be ignored (max hh:mm:ss).
Enable Triggering By
The next step is to specify the frequency of trigger response. 3 options are
available:
˜ Always - The default setting; Triggers event when conditions are met.
˜ Recurrence Pattern - Enables triggering only if conditions are met
during a specified time period. To specify the period, select the days
of the week that the trigger is active by checking the corresponding
boxes, and fill in a start time and end time for motion detection in
the From: and To: boxes.
˜ Never – The event is never triggered.
Triggered By
After the frequency is selected, triggering conditions can be set. Multiple
conditions can be set at once. Available options include:
˜ Motion Detection - Trigger when motion is detected.
o
In Window – Specifies the detection window that will trigger
the event.
Please refer to the section on Motion Detection for details.
˜ On Boot - Trigger when camera reboots.
˜ Video Loss & Tampering Detection - Trigger when video signal is lost
or tampering is detected. Please refer to the section on Tampering
Detection for more detail.
˜ Disk Full - Trigger when the SD disk installed in the camera is full.
143