Download User Manual Netti III XHD

5.1 Mounting of hip belt
5.2 Mounting of H-belt bar
Picture 1
• Pull the belt thorough the hole in the hip
belt bracket.
Picture 1
• Remove the push handles and pull the
H-belt attachment bar onto the push
handles from the lower end.
Picture 1
Picture 2
• Thread the belt back trough the belt.
clamp.
Picture 1
Picture 2
• Fix the push handles in correct position
and lock firmly. Then fix the bar at the
right position/height. The height should
be level with the shoulders of user.
.
Picture 2
Picture 3
• Fix the hip belt bracket to the rearmost
hole in the back hinge, using the enclosed
screws and nuts.
.
Picture 2
Picture 3
• Thread the belt through the rolls and lock
the belt by pulling the belt through the
belt clamp. Adjust to the requested lenght
of belt.
Picture 3
2 pcs 13 mm open-end spanner
Picture 3
14
Language: English Model: Netti III XHD Vesion: August 2012