Download Program and configuration manual for sequential

Page 7 / 59
ver. 3.3.1
30-10-2012
Since version 4.0.1.3 (full compatibility with 4.0B controller):
 Added Lithuanian and Italian language.
 Improved Auto-save mode.
 Extended information about the connected devices.
 Improved the recorder.
 Added colouring tables of corrections.
Since version 4.0.1.2 (full compatibility with 4.0B controller):
 Improved support for the 0-90ohm gas level sensor
 Optimized start-up and scaling program
 Added support for verifying after Autosetup
 Improved the Auto-save mode
 Introduced the manual model changes mode in Auto-save mode
 Added status of the device: GAS, PETROL, WAITING, OFF.
 Improved Recorder
Since version 4.0.1.0 (full compatibility with 4.0B controller):
 Added gas injectors test.
 Added change list In Workshop info.
 Added inspections info.
 Added Turbo and Mazda options In Auto Setup window.
 Added Idle model calibration.
 Added Corrections map.
 Added stripe indicating activity of chosen functions.
 Added upgrade to the Recorder (the ability to load and watch previously recorded
waveforms).
 Added colour changing of red values which are beyond range for appropriate work.
 Refreshed the look of the program.
●
●
●
●
●
●
●
●