Download Hardware Manual

USB-CANmodul
Transmit Section
The Transmit section provides the following information:
• Message:
identifier of the CAN message, hexadecimal format, ranging from 0 to
7FFh for 11-bit identifiers and from 0 to 1FFFFFFFh fro 29-bit identifiers
• Length:
data length code of the message (ranges from 0 to 8)
• Data:
values of the messages’ data bytes (up to 8) or the text Remote
request, if a remote frame shall be sent
• Period:
period of time between the last two message sent
Note:
If, at creation of the message, the period was set to 0, the text Wait is shown. In this case
the message can only be transmitted manually using the <Space> bar. Or the message is
sent automatically after a matching remote frame has been received.
•
Count:
number of messages sent with this identifier (no remote frames) since
last user reset
•
Trigger:
reason for the last transmission of the message Manual: manual
transmission by the user pressing the <Space> bar
•
Time:
period of time has passed for periodical sending
•
RTR:
remote frame has been received
Note:
Both sections are sorted by the CAN identifiers. That means no chronology is displayed.
In order to edit the Transmit list, the following menu commands are available:
•
Transmit New...:
Create a new transmit message.
window for the new message is shown.
•
Transmit Delete:
Delete the currently
the transmit list.
•
Transmit Edit...:
Edit the currently selected message.
•
Transmit Clear all:
Delete the entire transmit list.
•
Client Reset:
Reset the
connected
receive list.
48
selected
message counters
USB-CANmodul.
The
editor
message
from
and reset
Deletes
 SYS TEC electronic GmbH 2010
the
the
L-487e_22