Download Serial FLASH Programming User`s Guide

Informing TRACE32 about the Serial Flash Programming Algorithm
The following command is available to inform TRACE32 about the serial Flash programming algorithm:
FLASHFILE.TARGET <code_range> <data_range> <file>
Specify the serial Flash
programming driver and where it
runs in the target RAM.
Parameters
•
<code_range>
Define an address range in the target´s RAM to which the serial Flash programming algorithm is
loaded.
FLASH algorithm
32 byte
Figure: Memory mapping for the <code_range>
Required size for the code is size_of(<file>) + 32 byte
•
<data_range>
Define the address range in the target´s RAM where the programming data is buffered for the
programming algorithm.
©1989-2015 Lauterbach GmbH
Serial FLASH Programming User’s Guide
18
Scripts for SPI Controllers