Download My Book Live User Manual

MY BOOK LIVE
USER MANUAL
1. View or modify the following settings:
Time Zone
From the drop-down list, select the time zone where your
drive is located.
Date & Time
From the drop-down lists, select the current date and
time.
NTP Service
Select the check box to enable NTP service, which
automatically synchronizes your drive to update the time
and date.
If you want to change to another primary NTP server, click
Add New Primary, and then enter the URL address of
the new primary server.
2. If you have made any changes, click the Save button.
Updates
This section of the page enables you to set up the drive to update the firmware
automatically or to manually check for an update file:
A description, current version number, and date of last update of the My Book Live
firmware display.
Important: Wait for the My Book Live drive to finish powering up
(approximately three minutes) before configuring the drive. You will
know it is ready when the LED stops flashing and turns solid green
(normal) or blue (standby).
Check for Update
To manually check for new firmware availability and to optionally install new firmware:
1. Click the Check for Update button. The “Checking” message displays. If an
update is found, click OK.
2. If desired, click the Install & Reboot button. A progress bar displays. When
the process is complete, the network drive reboots.
CONFIGURING BASIC SETTINGS – 62