Download VNX Unified Storage Implementation Lab Guide

Step
10
11
Action
Next highlight Topology.


Verify it is set for a value of 2.
Read the other choices and their values under the Description.

Note: You should always use EMC-specific drivers. They are installed with settings
configured according to EMC best practices. Most manufacturers will have vendor specific
drivers available for download.
If your Team’s setup has more than one physical HBA then you can return to step 8 of this lab
and perform the same configuration on the other one if it is present on your host.

12
Else go to the next step.
Your HBAs have been installed and setup correctly.

Close the One Command Manager utility.
End of Lab Exercise 4 Part 1
45