Download User Manual

Usage
6.4.2 Information about getting in and out
Getting out of the mobility device:
1.
2.
3.
4.
WARNING!
Risk of serious injury or damage
Improper transfer techniques may cause serious injury
or damage
– Before attempting transfers, consult a healthcare
professional to determine proper transfer techniques
for the user and type of wheelchair.
– Follow the instructions below.
If you do not have sufficient muscle strength, you should ask
other persons for help. Use a sliding board, if possible.
Getting into the mobility device:
1.
2.
3.
4.
5.
6.
Position your mobility device as close as possible to your seat.
This might have to be done by an attendant.
Align casters parallel to the drive wheels to improve stability
during transfer.
Always switch your mobility device off.
Always engage both motor locks/clutches and free wheel hubs (if
fitted) to prevent the wheels from moving.
Depending on the armrest type of your mobility device, detach
the armrest or swivel it up.
Now slide into the mobility device.
1529686-Q
5.
6.
Position your mobility device as close as possible to your seat.
Align casters parallel to the drive wheels to improve stability
during transfer.
Always switch your mobility device off.
Always engage both motor locks/clutches and free wheel hubs (if
fitted) to prevent the wheels from moving.
Depending on the armrest type of your mobility device, detach
the armrest or swivel it up.
Now slide onto your new seat.
6.5 Taking Obstacles
6.5.1 Maximum obstacle height
You can find information about maximum obstacle heights in the
chapter entitled 11 Technical data, page 96.
6.5.2 Safety information when ascending obstacles
CAUTION!
Risk of tipping over
– Never approach obstacles at an angle but at 90
degrees as shown below.
– Put your backrest into an upright position before
climbing an obstacle.
69