Download USER`S MANUAL

3. Slide a Rubber Ring (74) onto the post on each Upright
(14). Refer to the inset drawing. Make sure that each
Rubber Ring is turned so the tapered side is toward
the thickest part of the post.
3
Post
Post
14
74
74
Tapered Side
4. Slide the upper end of one of the Handrails (2) onto the
post on one of the Uprights (14). Push the Handrail as far
forward as possible. (Note: It may be necessary to
pivot the Handrail to the side and back repeatedly
[see arrow B] while pushing on the Handrail [see
arrow A] to slide it fully into the Upright.) Tighten a
Handrail Screw (13) into the Handrail.
14
4
A
13
13
14
14
2
Attach the other Handrail (2) as described above.
2
5. With the help of a second person, carefully tip the
Uprights (14) down as shown.
B
Align the lower ends of the Handrails (2) with the holes in
the Extension Legs (41). Be careful not to scratch the
Extension Legs. Tighten a Handrail Bolt (15) with a
Handrail Washer (32) into each Extension Leg and
Handrail as shown. Notice the angle of the Handrail Bolt.
Attach the Bolt and Washer at the observed angle. It
should be close to the angle of the Handrail (see the inset
drawing).
5
14
32
32
2
With the help of a second person, carefully tip the
Uprights (14) back to the upright position.
15
32
41
Make sure that the Handrail Screws (13) (see drawing 4)
and the Handrail Bolts (15) are tightened.
6. Attach the Storage Latch (12) to the left Upright (14) with
the Latch Spacer (23) and two Latch Screws (88). Be
careful not to overtighten the Latch Screws.
15
2
15
2
41
6
14
23
7. Make sure that all parts are tightened before you use
the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor, place a mat
under the treadmill.
6
12
88