Download GSK983M User Manual 2 Version 4
Transcript
GSK983M Milling CNC System Operation Manual (Volume II: Operations) CONTENTS 4. OPERATIONS......................................................................................................................................1 4.1 Power On/off .................................................................................................................................1 4.1.1 Power on ..................................................................................................................................1 4.1.2 Power off ..................................................................................................................................1 4.2 Key Switch.....................................................................................................................................1 4.3 Operations Involving with the Operation Panel .........................................................................1 4.3.1 Operation panel........................................................................................................................1 4.3.2 Emergency stop (red)...............................................................................................................2 4.3.3 Selection mode.........................................................................................................................3 4.3.4 Operations involving with manual operation .............................................................................3 4.3.4.1 Jog feed .............................................................................................................................3 4.3.4.2 MPG feed...........................................................................................................................4 4.3.4.3 Manual absolute ................................................................................................................5 4.3.5 Manually returning to reference point (reference position) .......................................................9 4.3.6 Operations on automatic running ...........................................................................................10 4.3.6.1 Start of automatic operation .............................................................................................10 4.3.6.2 Suspension of automatic operation..................................................................................10 4.3.6.3 Single block .....................................................................................................................10 4.3.6.4 Restart after feed hold or stop .........................................................................................11 4.3.6.5 The manual operations in automatic run..........................................................................11 4.3.6.6 The MDI operations in automatic run ...............................................................................11 4.3.6.7 Skipping over optional blocks ..........................................................................................12 4.3.6.8 Feedrate override ............................................................................................................12 4.3.6.9 Dry run .............................................................................................................................12 4.3.6.10 Machine lock..................................................................................................................12 4.3.6.11 Display lock....................................................................................................................12 4.3.6.12 Mirror image...................................................................................................................12 4.3.6.13 Rapid traverse override .................................................................................................13 4.3.6.14 External workpiece number search function ..................................................................13 4.3.7 JOG feed at any angle ...........................................................................................................14 4.3.8 Manual insertion .....................................................................................................................15 4.3.8.1 Inserting operations by MPG(manual pulse generator/handwheel) .................................15 4.3.8.2 Manual inserting movement by MPG...............................................................................16 4.4 The Display and Operations of the MDI/LCD Panel with LCD Characters .............................17 4.4.1 Status display .........................................................................................................................18 4.4.2 Key input ................................................................................................................................18 4.4.3 Display of program numbers and sequence numbers ............................................................19 4.4.4 Alarm display (function button ALARM)..................................................................................20 4.4.5 Operator information ..............................................................................................................21 4.4.6 Display of actual position and reset (function key POSITION) ...............................................21 4.4.7 Indication of instruction value (function button COMMAND) ..................................................22 4.4.8 Setting (function button SETTING) ........................................................................................24 4.4.8.1 Display and setting of input, output, etc ...........................................................................24 4.4.8.2 Display and setting of user macro variables ....................................................................26 4.4.9 Operating through MDI (function key COMMAND) ................................................................27 4.4.10 Start of MDI motion...............................................................................................................28 4.4.11 Reset ....................................................................................................................................28 4.4.12 Tool position offset................................................................................................................29 4.4.13 Setting and display of workpiece origin offset (Optional) ......................................................30 4.4.14 Measurement of tool length ..................................................................................................31 4.4.15 Program display (function button PROGRAM).....................................................................31 4.4.16 Program number search (function key PROGRAM) ............................................................33 4.4.17 Inputting a program with keys...............................................................................................33 III