Download Bachelor Thesis - e
Transcript
areas. On the third generation networks other more accurate approached can be used [11] [12]. 2.3.2. Angle of Arrival-based This method is also called Direction of Arrival (DOA), it uses antenna arrays to calculate the incident angle. If a terminal is connected to an antenna and is in line of sight (LOS), the antenna array can calculate the direction by measuring the phase difference using the array or the signal strength. In order to know the position, this method will need another estimation of the incident angle. Comparing the result of both antenna and using trigonometry, the position of the device can be calculated. Figure 2.3.2. – Angle Of Arrival This method can be a good approach in rural areas, since it is difficult to find a group of three antennas close enough to be effective, this approach can compute the position with only two antennas. However, some problems can be found in this method because some shadows in the antennas range and the reflexive signals, which have a different angle of arrival. Also, the proper installation of the antenna is a costly process and a slight change in the state of the antenna could end important precision problems [11] [12]. 2.3.3. Received Signal Strength-based This procedure is called Received Signal Strength (RSS), and it uses the power of the signal between the device and the Base Transceiver Station (BTS). When a device goes away form the BTS, the signal power decrease the distance to the second power in the air. Each BTS has a Received Signal Strength Indication (RSSI), which is the power of the signal from a specific device and so, the distance from the BTS, can be measured. The method needs three BTS to calculate the position of the device, since with one or two BTW only the distance away from them can be calculated. This process is made be circular triangulations. Circular triangulations use the intersection among al lest three circumferences. Each circumference has as centre the respective BTS and as radius the RSSI. The precision of this triangulation method resides on the precision how the RSSI is taken. The far away 22