Download ES321 User Manual

8
Configuring Symbology
8-3-8. Remove Trailing Characters
TrunEnd parameter allows you to specify the number of characters which you intend to
remove backwards from the end of UPC-E barcode. In doing so, you are able to format the
decoded message beforehand by taking out the necessary barcode parts and preserve the
desired segments for your benefit. Follow the below procedure to complete the
configuration:
TrunEnd
D35E0
*D35E0*
(Length: 1 digit / Range: 0-255)
Procedure
(1) Scan Enter barcode.
(2) Scan TrunEnd barcode to specify the number of characters to delete backwards from
the end of the decoded data.
(3) Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal value
barcodes representing the desired number in the range of 0 to 255. For instance, to
remove the last two digits out of every UPC-E symbol, then scan 2 to assign the
specified decimal value “2”.
(4) Scan SET barcode to complete the variable-binding operation.
(5) Scan End barcode to complete the configuration.
8-3-9. Set Position for Inserting Custom Info
Ins0Pos and Ins1Pos parameters allow you to specify the specific position within a barcode
to insert your own custom message as to better format barcode data. However, to have the
mentioned feture take effect, the group of parameters in this section necessarily pairs up with
that in Section 8-2-10 which further demonstrates how to define what contains in inserted
infroamtion. Please be advised that Ins0Pos has to work with Ins0PosChar and Ins1Pos
with Ins1PosChar.
Ins0Pos
D36E0
*D36E0*
Ins1Pos
D37E0
*D37E0*
(Length: 1 digit / Range: 0-255)
(Length: 1 digit / Range: 0-255)
Enter
*/$%ENTR*
210
End
*ZEND*