1
Download Introduction
Transcript
Standard Default Parameters Table A-1 Standard Default Parameters Table (Continued) Parameter Convert Case Parameter Number Default Page Number No Case Conversion 6-14 RS-232 Host Types Standard1 7-7 Baud Rate 9600 7-8 Parity Type None 7-11 Stop Bit Select 1 Stop Bit 7-12 Data Bits 8-Bit 7-12 Check Receive Errors Enable 7-13 Hardware Handshaking None 7-13 Software Handshaking None 7-15 Host Serial Response Time-out 2 Sec 7-17 RTS Line State Low RTS 7-18 Beep on <BEL> Disable 7-18 Intercharacter Delay 0 msec 7-19 Nixdorf Beep/LED Options Normal Operation 7-20 Ignore Unknown Characters Send Bar Code 7-20 Port Address None Selected 8-4 Convert Unknown to Code 39 Disable 8-5 Wand Emulation Host Types Symbol OmniLink Interface Controller1 9-5 Leading Margin 80 msec 9-6 Polarity Bar High/Margin Low 9-7 Ignore Unknown Characters Ignore 9-7 Convert All Bar Codes to Code 39 Disable 9-8 Convert Code 39 to Full ASCII Disable 9-9 RS-232 Host Parameters IBM 468X/469X Host Parameters Wand Emulation Host Parameters 1User selection is required to configure this interface and this is the most common selection. A-3
