Download User Manual

USER MANUAL
KBU-E0800-FG / E1200-FG / E1600-FG / E3200-FG SINGLE ZONE MODELS
THERMOELECTRIC WINE CELLAR
www.kingsbottle.com
CONTENTS
CONGRATULATIONS
Congratulations and thank you for choosing
our KingsBottle Wine Cellars . We are sure
you will find your new appliance a pleasure
to use . Before you installing and operating
the wine cellar, we recommend that you
read through the relevant sections of this
manual, which provides a description of your
wine cellar and its functions .
To avoid the risks that are always present
when you use an electric appliance, it is
important that the appliance is installed
correctly and that you read the safety
instructions carefully to avoid misuse and
hazards .
We recommend that you keep this
instruction booklet for future reference and
pass it on to any future owners .
After unpacking the appliance, please check
it is not damaged . If in doubt, do not use the
appliance but contact us or your local
customer care centre
www.kingsbottle.com
TABLE OF CONTENTS
CHAPTER
CONTENTS
PAGE
Part I
Important Safety & Pre-Use Instructions
3
Part II
Diagram & Description of Wine Cellar
4
Part III
Cutout Dimension Illustrated
5
Part IV
How to Install
6
Part V
Operating Your Wine Cellar
6
Part VI
Technical Data
7
Part VII
Care & Maintenance
8
Part VIII
Troubleshooting Guide
9
Part IX
Warranty Information
13
2
SAFETY
PART I
IMPORTANT SAFETY
INSTRUCTIONS
Please read the user manual carefully and store in a handy
place for later reference . The symbols you will see in this
booklet have these meanings:
This symbol indicates information concerning
your personal safety
This symbol indicates information on how to
avoid damaging the appliance
This symbol indicates tips and information
about use of the appliance
This symbol indicates tips and information
about economical and ecological use of the
appliance
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK,
OR INJURY WHEN USING YOUR APPLIANCE, FOLLOW
THESE BASIC PRECAUTIONS:
1. Read all instructions before using the wine cellar.
2. DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not only problems of
the past. Junked or abandoned appliances are still
dangerous… even if they will “just sit in the garage for a few
days”.
3. Before you throw away your old wine cellar:
•
•
4.
5.
6.
1.
2.
3.
It is essential the power point is properly earthed to
ground . Consult a qualified electrician if you are
unsure .
4. Don’t use extension cords or adapter plugs with this
cellar .
5. If the power cord is damaged, have it replaced by a
qualified service technician .
6. Unplug the cellar before cleaning it, or changing the
light bulb to avoid electric shock .
7. Never unplug the cellar by pulling the electrical cord
as this may damage it. Grip the plug firmly and pull
straight out .
8. It is recommended that yuo keep the wine cooler in a
place where the ambient temperature is between 7780.6°F
9. Don’t put the cellar in frosty or unprotected areas like
a garage or on the verandah .
10. Keep the cellar out of direct sunlight .
11. Don’t locate the cellar near stoves, fires or heaters .
12. When installed correctly, your cellar should:
• Have adequate space at the back and sides for air
circulation (refer to page 6) .
• Be aligned to the surrounding cupboards .
BEFORE USING YOUR WINE CELLAR
1. Remove the exterior and interior packing.
2. Before connecting the wine cellar to the power source,
let it stand upright for approximately 24 hours. This will
reduce the possibility of a malfunction in the cooling
system from handling during transportation.
3. Clean the interior surface with lukewarm water using a
soft cloth.
Take off the door.
Leave the Shelves in pieces so that children may
not climb inside easily.
Never allow children to operate, play with, or crawl
inside the appliance.
Never clean appliance parts with flammable fluids.
The fumes can create a fire hazard or explosion.
Do not store in the vicinity of any other appliance. Do
not store near gasoline or any other flammable
vapors. The fumes can create a fire hazard or
explosion.
The cellar must be plugged into its own dedicated
110-115V, 50/60Hz AC electrical outlet .
The plug must be accessible when the cellar is in
position .
THERMOELECTRIC WINE CELLAR
www.kingsbottle.com
3
FEATURES
PART II
DIAGRAM & DESCRIPTION OF WINE CELLAR
SINGLE ZONE WINE CELLAR MODELS: KBU-E0800-FG / E1200-FG / E1600-FG / E3200-FG
1. FOOT
7. BOTTOM DOOR HINGE
2. POWER CORD
8. WATER TRAY
3. DOOR FRAME
9. SHELF
4. GLASS DOOR
10. COLD FAN MASK
5. RECESSDE HANDLE
11. LAMP COVER
6. TOP DOOR HINGE COVER
12. DOOR SEAL
YOUR WINE CELLAR ALSO INCLUDES THE FOLLOWING:
• Instruction manual
Note: Above diagram and description is for SINGLE ZONE WINE CELLAR MODELS: KBU-E0800-FG / E1200-FG / E1600-FG /
E3200-FG series
www.kingsbottle.com
4
DIMENSIONS
PART III
CUTOUT DIMENSION ILLUSTRATED
KBU-E3200-FG
15.7”W x 20.5”D x 33.5”H
(400W x 520D x 850H mm)
KBU-E1600-FG
17.1”W x 19.3”D x 19.9”H
(435W x 490D x 500H mm)
KBU-E1200-FG
14”W x 19.8”D x 19”H
(355W x 502D x 483H mm )
MODEL
WIDTH
DEPTH
HEIGHT
KBU-E3200-FG
15.7”
400mm
20.5”
520mm
33.5”
850mm
KBU-E1600-FG
17.1”
435mm
19.3”
490mm
19.9”
500mm
KBU-E1200-FG
14”
355mm
19.8”
502mm
19”
483mm
KBU-E0800-FG
9.9”
252mm
20”
507mm
18”
457mm
KBU-E0800-FG
9.9”W x 20”D x 18”H
(252W x 507D x 457H mm )
THERMOELECTRIC WINE CELLAR
www.kingsbottle.com
5
INSTALLATION
PART IV
How to install
1. Install wine cooler in a convenient location away from extreme heat and cold. Allow sufficient clearance between the wine cooler
and side wall so that the door can open without obstruction. Wine cooler is not designed for recessed installation.
2. Select a space with strong floor support.
3. Allow minimum 2 inches of space between the wine cooler's sides and side wall, minimum 4 inches between back and the wall.
Wall
Side Wall
Side Wall
Wine
Cooler
Free-standing installation:
A free-standing installation will allow you to install the wine cooler in almost any place you desire.You must follow the
installed instructions,installation clearance, and leveling the wine cooler.
POWER CORD REPLACEMENT
If the Wine Cooler's power cord is damaged, have it replaced by a qualified repair agent.
PART V
OPERATING YOUR WINE CELLAR
It is recommended that you keep the wine refrigerator in a place where the ambient temperature is between 77-80.6°F. If the ambient
temperature is above or below recommended temperature, the performance of the unit may be affected. For example, placing in
extreme cold or hot conditions may cause interior temperature to fluctuate. The range of 50-66°F may not be reached.
The display reflects the temperature at the center of the wine refrigerator. Temperature may fluctuate approximate +/-4 degrees at the
top to the bottom.
The temperature may fluctuate depending on whether or not the interior light is on or off or whether the bottles are located on the
upper/middle or lower section.
TEMPERATURE SETTINGS FOR WINE SERVICE:
Different varietals of wine require different temperature setting. The recommended temperature ranges for serving different
varietals of wine are listed below.
! Red Wines：52-64°F（11-18°C）
! White Wines：46-51°F（8-11°C）
You can set the temperature as you desire by using the press buttons. Use the “▲” and “▼” to adjust the temperature by 1°F among
54-66°F / 46-66°F. You can turn the interior light on or off by pressing the “light” button.
www.kingsbottle.com
6
TECHNICAL DATA
PART VI
TECHNICAL DATA
MODEL NO.
KBU-E3200-FG
KBU-E1600-FG
KBU-E1200-FG
KBU-E0800-FG
ACCOMMODATION
(BOTTLES)
32
16
12
8
TYPE OF COOLING
Thermoelectric cooling
system
Thermoelectric cooling
system
Thermoelectric cooling
system
Thermoelectric cooling
system
CLIMATE TYPE
N
N
N
N
ELECTRICITY PROTECTION
GRADE
I
I
I
I
110-120V AC/60Hz
110-120V AC/60Hz
110-120V AC/60Hz
110-120V AC/60Hz
100W
70W
50W
50W
54-66 °F
54-66 °F
54-66 °F
46-66 °F
NET WEIGHT
53.1 lbs (24.1KGS)
32.6 lbs (14.8 KGS)
26.9 lbs (12.2K GS)
20.7 lbs (9.4 KGS)
GROSS WEIGHT
60.2 lbs (27.3 KGS)
36.6 lbs (16.6 KGS)
30.4 lbs (13.8 KGS)
23.8 lbs (10.8 KGS)
15.7”W x 20.5”D x
33.5”H
(400W x 520D x 850H
mm)
17.1”W x 19.3”D x
19.9”H
(435W x 490D x 500H
mm)
14”W x 19.8”D x 19”H
(355W x 502D x 483H
mm )
9.9”W x 20”D x 18”H
(252W x 507D x 457H
mm )
NOMINAL
VOLTAGE/FREQUENCY
RATED POWER(W)
AMBIENT TEMPERATURE
DIMENSION
THERMOELECTRIC WINE CELLAR
www.kingsbottle.com
7
MAINTENANCE
PART VII
CARE & MAINTENANCE
CLEANING YOUR WINE CELLAR
BEFORE CLEANING: Turn off the power, unplug the appliance, and remove all items including all shelves.
• Wash the inside surfaces with warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda with
a quart of water.
• Wash the shelves with a mild detergent solution.
• Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.
• Make sure the power is off before cleaning.
• Unscrew the water box at the bottom, and wash it.
• It is recommended to clean the unit completely inside and out at least every three months to maximize the longevity of the wine cellar.
VACATION TIME
Short vacations: You may leave the Wine Cellar operating during vacations of less than three weeks.
Long vacations: If the appliance will not be used for several months, remove all items and turn off the appliance. Clean and dry the
interior thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if necessary.
MOVING YOUR WINE CELLAR
1.
2.
3.
4.
5.
Remove all items.
Securely tape down all loose items (shelves) inside your appliance.
Turn the adjustable leg up to the base to avoid damage.
Tape the door shut.
Be sure the appliance stays secure in the upright position during transportation. Also protect the outside of the appliance with a
blanket or similar item.
www.kingsbottle.com
8
TROUBLESHOOTING
PART VIII
TROUBLESHOOTING GUIDE
You can solve many common wine refrigerator problems easily, saving you the cost of a possible service call. Try the suggestions
below to see if you can solve the problem before calling the customer service.
PROBLEM
Wine refrigerator
does not operate.
Wine refrigerator is
not cold enough.
The light does not work.
Vibrations.
The wine refrigerator seems
to make too much noise.
The door will not close
properly.
LED could not display.
Press-buttons are
not functional.
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or a blown fuse in your home.
Check the temperature control setting.
External environment may be too hot.
The door is opened too often.
The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct clearances.
Call the service center.
Check to assure that the wine refrigerator is level.
The wine refrigerator is not level.
Check the fan.
The wine refrigerator is not level.
The doors were reversed and not properly installed.
The seal is weak.
The shelves are out of position.
Main control board does not work.
Control panel is damaged.
THERMOELECTRIC WINE CELLAR
www.kingsbottle.com
9
NOTES
www.kingsbottle.com
10
NOTES
THERMOELECTRIC WINE CELLAR
www.kingsbottle.com
11
NOTES
www.kingsbottle.com
12
WARRANTY
PART IX
WARRANTY INFORMATION
Please speak to your Retailer before calling BTO AMERICA LIMITED if you did not purchase your Wine Cellar directly from
BTO AMERICA LIMITED
Limited warranty – 90 day replacement plan with a free 9 months upgrade, totaling 1 year, on parts and labor from the date of shipment.
For customer service, please contact BTO AMERICA LIMITED by e-mail ( [email protected]) .
The limited warranty does not cover: Damage due to such things as accident, misuse, abuse, mishandling, neglect, unauthorized repair
or any other cause beyond the control of the seller whether similar or dissimilar to the foregoing. Purchaser understands and acknowledges
that the goods sold here are wine cellars, which house wine. Purchaser assumes all the risk of using these units, including risk of spoilage,
humidity variations, temperature variations, leaks, fires, water damage, mold, mildew, dryness and similar perils that may occur.
THERMOELECTRIC WINE CELLAR
www.kingsbottle.com
13