Download Series 90 Programmable Controllers Flow Computer User`s Manual

Transcript
Preface
t
This manual provides the information necessary to install and use the Series 90 Flow
Computer which is a Series 90-30 or Series 90-70 PCM based MegaBasic program. This
program calculates the gas flow rate and volume for orifice meter applications in
accordance with the AGA3 standard using either the NX-19 or Standing Katz
supercompressibility methods.
t
Features and Benefits
Features and benefits of the Flow Computer are:
Feature
Benefit
PLC based
High integration flexibility leads to lower system costs.
Choice of Series 90-70 or Series 90-30 PLC
Series 90-30 facilitates low cost SCADA applications.
Series 90-70 for higher performance or VME applications.
Performs AGA3 gas calculations
Industry standard.
Supports NX19 or Standard Katz supercompressibility
Gas composition can be manually entered from an operator
interface.
Built-in operator interface
Lower system cost since no external operator interface or
computer is required to configure or monitor the Flow
Computer.
CIMPLICITY 90-ADS operator interface
Flow Computer operator interface can be customized to fit
application.
Contents of this Manual
Chapter 1. Introduction to the Flow Computer: Provides an introduction to the Series
90 Flow Computer.
Chapter 2. Installation and Configuration: Describes the hardware requirements and
how to install the hardware and software in your Series 90-30 or Series 90-70
Programmable Logic Controller system.
Chapter 3. Operation of the Flow Computer: Describes operation of the Flow Control
computer.
tMegaBasicis a trademark of Christopher Cochran.
GFK-0685
iii