Download Double Matrix Professional

Double Matrix Professional
User manual
5. Beginning of operation
5.1 Fluid tank re-fill
We recommend you to use only the clearaudio “Pure Groove” cleaning fluid for a perfect result and for
the safety of your records (also available under: www.analogshop.de).
Attention:
Foaming fluid can damage the machine and void the warranty!
The fluid tank has a maximum capacity of 0,25 litre. Open the fluid tank by removing the round top
cap. Fill the fluid with the supplied filling funnel into the tank.
There is no necessity to worry if you filled too much fluid into tank, just wipe the spilled fluid off with a
cloth.
5.2 Record cleaning, vacuum drying, electrostatic discharging
For the very first record cleaning process, we recommend you, to use a defective or very
used record to get familiar wit the machine.
1. Take off the record clamp by twisting the lock cap to the left (pic. 11, page 10). Place the record
over the spindle and put the record clamp back. Tighten it firmly, so that the record can not slip while
vacuuming.
2. Place the top upper arm over the record, while swinging it towards the spindle.
With light pressure on the top of the cleaning arm, the upper and lower cleaning arms will be pushed
together due to the inserted magnets.
3. By pushing the button „LIQUID“ the rubber tubes will fill up with the cleaning fluid. Wait until the
fluid comes out of the cleaning arms onto the surface of the record. The micro fibre brushes should be
wet before switching them onto the platter.
4. To let the platter turn, push the button „POWER“. By using the button „PLATTER“ the platter will be
in rotation. By using the button “PLATTER SPEED” you can control the speed of the platter and also the
cleaning process of your record. Now be aware that the fluid should build a closed surface by pushing
the “LIQUID” button quickly, maybe several times.
5. The platter should turn in each direction 3 to 5 times, depending on the dirt level of the record.
Caution: Please take care that there is enough fluid on the record surface.
For a very intense cleaning, you can stop the platter during the cleaning process.
Just wait 30 to 60 seconds for the fluid to sink in.
Page 11
 clearaudio electronic GmbH 2011