Download EQUATOR - Telenet Service

Page 4
5.2 DETAIL OF CONTROL PANEL
DIAL 1 : GENERAL OPERATION
The adjacent lights indicate the selected position.
Position 0: Appliance stopped. The light opposite indicates the oven is
turned on (normal standby position).
Start Position: The control panel is activated but the heat and ventilation
are not on yet. It is possible to select cooking parameters.
Cooking start: The heat and ventilation come on if the door is closed,
according to the selected parameters. The cooking time (if selected) starts
counting down (flashing point in time indicator).
Oven cooling Position: Provides rapid cooling, control by use of this dial.
NOTE: Over 210°C, only the ventilation works. Water inje ction is only
activated below 210°C.
Cleaning cycle position: Use every day, when cooking is finished. The
automatic cycle ensures optimal cleaning, in total safety and in a minimum
of time.
See section Maintenance of Equator oven.
BONNET CIDELCEM GRANDE CUISINE
Siége social:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex