Download "user manual"
Transcript
5. ELECTRICAL CONNECTION TO THE FURNACE ! WARNING Never connect a 120-volt AC circuit to the terminals of the furnace interlock (standard wiring). Only use the low voltage class 2 circuit of the furnace blower control. FOR A FURNACE CONNECTED TO A COOLING SYSTEM: On some older thermostats, energizing the “R” and “G” terminals at the furnace has the effect of energizing “Y” at the thermostat and thereby turning on the cooling system. If you identify this type of thermostat, you must use the ALTERNATE FURNACE INTERLOCK WIRING. STANDARD FURNACE INTERLOCK WIRING THERMOSTAT TERMINALS FOUR WIRES TWO WIRES heating only W R G W 4 WIRES G Y THERMOSTAT TERMINAL 2 WIRES heating only wiring nuts W RR NO NC G C C C YY Y FURNACE 24-VOLT TERMINAL BLOCK R UNIT TERMINAL CONNECTOR Y NO C NC I OC OL Y R G B G UNIT TERMINAL CONNECTOR R NO C NC I OC OL Y R G B W ALTERNATE FURNACE INTERLOCK WIRING FURNACE 24-VOLT TERMINAL BLOCK TWO WIRES 2 WIRES COOLING SYSTEM VE0108A 14 COOLING SYSTEM