1
Download IRIS-Net - Bosch Security Systems
Transcript
IRIS-Net REMOTE AMPLIFIER | en 247 Clicking this switch activates the LOCK indicator on the amplifier’s rear panel and all amplifier front panel LEDs, as well as in the amplifier’s front panel window in the IRIS-Net software. This function is meant for identifying or searching an amplifier in a large system setup. The number field indicates the set amplifier object number. This is an ascending number which will be assigned automatically when the amplifier will be created in the IRIS-Net work sheet. It is the same number as shown on the device front panel in IRIS-Net. These buttons allow assigning amplifier channels to the RCM-28 OMNEO output 3, which is reserved for monitoring. This allows monitoring any amplifier input or output signals within an installation. INPUT A / B selects the corresponding input signal while OUTPUT A / B allows switching between the output signals of channels A and B. Simply click on an amp channel’s icon to select it for monitoring. The corresponding channel is assigned to OMNEO output channel 3 of the amplifier. Any previous selection is simultaneously canceled, so that only the actually selected amp channel can be monitored. Clicking the button of an active amp channel separates the channel from the monitor bus. For monitoring you have to select the desired amplifier output 3 in the Network View dialog and assign it to an OMNEO/Dante receiver, e.g. the Dante Virtual Sound Card. This field indicates the active factory or user preset. Each remote amp has two factory setting F01 (linear thru) and F02 (DSP Bypass) offering linear settings and thirty user-programmable presets U01...U30 for storing random user data. Loading and saving presets is done in the Setup & Control window. Clicking on the SET button opens the Setup & Control Window, which provides access to all amplifier- and DSP-parameters, control and monitoring functions plus additional function groups. POWER CONSUMPTION indicates the current power consumption of the power amplifier in VA. This soft-key allows switching an amplifier on or off. The STANDBY and POWER indicators signal the actual operational status. The Config & Info window allows programming individual power-on delays for each amplifier. HINT: The power-on delay defaults to „Object No. * 150 ms“. For object no. 8 the power-on delay default would be for example: 8 *150 ms = 1200 ms. These indicators show the amp’s actual operational status. STANDBY lights whenever the amplifier is in stand-by mode. POWER lights whenever the amplifier is powered-on and ready for operation. If neither one of the indicators lights, the amplifier is either off-line or powered-off. Setup & Control The Setup & Control window allows configuring all amplifier parameters. It also provides access to different test functions. The window is divided into several pages according to the corresponding function groups: Window Description Config & Info This page provides information about the amplifier and allows making several basic settings as well as programming control functions. DSP The DSP page provides an overview plus access to all DSP functions (Filter, Delay, X-Over, Limiters) of the amplifier. Speaker This page allows loading and displaying speaker data. Bosch Sicherheitssysteme GmbH User Manual 09-Jul-2015 | 3.0.0 | F.01U.119.956
