Download AdderLink iPEPS

w
w
w
.
ad
d
w
w
m
w
.a
d
d
e
r.
co
PO
W
ER
LN
100 K RE
LO M V
C P NC
W
R
w
w
ad
w
.
PO
W
ER
d
e
r.
co
m
LN
100 K RE
LO M V
C P NC
W
R
w
w
m
o
r.
c
e
d
LN
100 K RE
LO M V
C P NC
W
R



PO
W
ER

w
.
PO
W
ER
ad
Adder Power Squid Cable

LN
100 K RE
LO M V
C P NC
W
R

m
e
r.
co
To use a common power adapter to supply multiple iPEPS units
Available as an optional item, the Adder Power Squid cable allows you to
distribute power from an adapter to a maximum of four iPEPS units.
Note: Do not attempt to power more than two iPEPS units using the standard
5V 2A power adapter unit. For three or four iPEPS, use only the higher capacity
5V 4A adapter.
1 Connect a power output plug of the squid cable to the input socket of each
iPEPS unit.
Note: Ensure that switch 1 on each iPEPS is set to the appropriate setting for
your installation - see Power supply issues and options on the previous
page.
2 Connect the low voltage output connector from the power supply unit to
the input socket of the power spider cable.
3 Connect the IEC connector of the supplied country-specific power lead to
the socket of the power supply.
4 Connect the power lead to a nearby mains supply socket.
Input from the
power adapter
10