Download Operating Manual PacDrive Controller P600

8.5 Diagnostic messages
Ext. diagnosis
Meaning
prog xhhhhhhhh
IEC program code is too big
bad version
The IEC program is not compatible with the PacDrive controller firmware
(V00.10.00 or higher)
data xhhhhhhhh
IEC data area is too large -> adjust number of data segments
ret xhhhhhhhh
The retain area is too large
DOWNLOAD
Unable to load and prepare the IEC program.
.. miscellaneous
Other data errors
Cause of "data xhhhhhhhh":
A project was developed for an older version of the PacDrive controller firmware. In
this project, the number of data segments is greater than two (e.g. three). If you now
transfer the program to the controller, EPAS-4 will display the following message after
the transfer is complete: "IEC program cannot be loaded!"
▶
If this happens, reduce the number of data segments to two and transfer the
project to the controller again after the conversion process is complete.
Cause of "DOWNLOAD":
A subsequent error is involved in this case.
▶
Refer to the previous error message (e.g. 312 "Parameter relocation failed" (see
8.5.4.13 312 Parameter relocation failed)).
▪
There is no IEC program in the PacDrive controller or the IEC program is in‐
compatible.
Transfer the IEC program again using EPAS-4.
▶
▪
▶
▶
▪
▶
The IEC program code, IEC data area or IEC retain area in the PacDrive con‐
troller is too large.
See DiagExtCode.
Adjust project.
The setting in EPAS-4 > Project > Options > Conversion options in the item
"Number of Data Segments" is less than 2 (DiagExtCode = ret xhhhhhhhh).
Increase the number of data segments.
205 Impermissible parameter value
Diagnosis class (see 8.1 Diagnosis Classes) (standard): 4
A parameter has an impermissible value. The DiagExtCode parameter in the control
configuration or message logger can be used to determine the logical address of the
parameter that contains an impermissible value. This allows assignment to the control
configuration.
▪
ELAU AG
Ext. diagnosis: BaudRate=<impermissible value>M
In V00.15.00 or higher, the PacDrive controller supports the BaudRate SERCOS
parameter.
2, 4, 8 and 16 MBaud values are supported in general.
Only specific values are supported depending on the type of PacDrive controller
(Max-4, CXX, PXX). Each value is dynamically checked when written. Incorrect
PacDrive Controller P600
Page 99