Download inCoris TZI - Sirona - Technical Documentation

Transcript
Sirona Dental Systems GmbH
6 Creating the restoration
Translucent zirconia ceramic blocks and blanks for CEREC and inLab
6
Creating the restoration
6.1 Scanning, designing and milling
inCoris TZI can only be processed with CEREC/inLab software version
4.0 or higher. The inCoris TZI blanks are stored in the material dialog as
of inLab SW 15.0 or higher.
inCoris TZI
Software 4.0 or higher
If you are using software 4.0 or higher, select Sirona/inCoris TZI in the
material dialog.
Details are documented in the "CEREC SW / inLab SW” User Manual.
After the grinding/milling process and prior to sintering, a diamond burr
milling tool has to be used to separate the restoration.
To prevent milling residues from remaining in the fissures, the restoration
can be briefly steamed off or cleaned with water and a soft toothbrush.
6.3 Pre-drying
To prevent inhomogeneous coloring of the restorations caused by varying
liquid penetration characteristics, the restorations need to be dried first of
all.
Fragment TZI
Predrying can be carried out in various ways. We recommend one of the
following:
● 30 minutes at 80°C (176°F) in the drying cabinet
or
● 10 minutes at 150 ℃ (302°F) in the drying cabinet
NOTICE
In the case of high humidity
In an environment with a high level of humidity, the restorations can
absorb moisture after drying. For this reason, sintering must take place
within a maximum of one hour after drying.
63 59 801 D3487
D3487.201.06.07.02
11.2015
9
båÖäáëÜ
6.2 Rework of the grounded/milled restoration