Download BE3200 Multi-Channel Test Sequencer

BE3200
8.3
System commands
The following is a summary of the available system commands.
CL
Clear
ID
Identification
MO
Switch to a different operation mode
SO
Set output
CO
Clear outputs
ST
Status
AB
Abort status
ER
Error code
TS
Test
DV
Default values
Command:
!CL
Request:
n/a
Clear
Syntax
Description
The CL command is only used to get the sequencer out of the
error states (failed and aborted). Be sure to request all needed
error and status information before sending the clear
command, because this information is lost after the CL
command.
Request configuration
Syntax
Command:
n/a
Request:
?ID
Example reply: !ID3200;RV2.00;CH032;IQ1
Description
This command is used to find out which hardware is connected.
In case of the example reply, it’s a BE3200, firmware version
2.00, 32 output channels, start qualifier inputs (and/or matrix)
installed. When master-slave mode is selected, the number of
channels includes the channels of the slave sequencer.The
other items refer to the master sequencer only.
Operating mode selection
Syntax
Command:
!MOn
Request:
?MO
Example reply: !MO1
Description
This command is used to select the operating mode for the
sequencer:
n: 0 = off-line, 1 = stand-alone, 2 = master-slave
It is not possible to switch between modes 1 and 2 directly.You
should select Idle mode first.
66
I2717-2.0 en