Download Keithley -

Transcript
CAUTION
MODEL225
CAUTION
IF THE DECADECURRENTDIALS ARE SET TO O-O-O and if the Output Selector switch is not at STANDBY,a
COMPLIANCEVOLTAGEup to 100 volts may be present at the oucpuc terminals.
For r&x"rn
operator
safety the Model 225 Current Source should always be set to STA!IDBYmode when no current output is
needed. The Output Selector switch (S105) should also be set to STANDBY prior to changing current
dial seteings and/or Voltage Compliance.
This will ensure that no transient
currente will be
generated.
WARNING
This insrrument is no? approved for use in "hazardous
Electrical
Code, Classes I, II, and III.
locations"
as defined
in the National
Class I: Those locations in which flameble
gases or vapors are or may be present in the air in
quantifies
sufficient
to produce explosive or ignitable
mixcures.
Class II:
Those locations that are hazardous because of the presence of combustible dust.
Class III:
Those locations that are hazardous because of the presence of easily ignitable
fibers
or flyings.
0676
5