Download Manual

PN5212 / PN5320 User Manual
4. Key in the email address (addresses) of where you want the event reports
sent to in the To field.
Note: If you are sending the report to more than one email address,
separate the addresses with a semicolon. The total cannot exceed
256 Bytes.
Log Server
Important transactions that occur on the Power Over the NET™ device, such
as logins and internal status messages, are automatically generated and kept by
an ATEN Log Server program. Specify the MAC address of the computer that
the Log Server resides on, and the service port number used. The valid port
range is 1-65535. The default port number is 9001.
Note: 1. Make sure that the port number you specify here matches the one you
specify in the Log Server’s configuration settings (see Configure,
page 99).
2. The port number must different than the one used for the Program
port (see Service Ports, page 63).
Installation and operation of the Log Server is discussed in Chapter 10. The
Log File is discussed on page 85.
68