Download international 8700
Transcript
TROUBLESHOOTING GSM 8700/6700 Cellular Subscriber Group Troubleshooting Introduction Assembly replacement level troubleshooting and repair of the GSM 8700/6700 personal telephone is limited to those components listed in the Replacement Parts List. See ÒReplacement PartsÓ on page 49. It is recommended that known good replacement parts and assemblies be available to be used for troubleshooting by substitution, and for replacement of parts/ assemblies found to be defective. Troubleshooting And Repair © 1996 Motorola, Inc. NOTE Defective Logic/RF assemblies must be replaced with pre-tested, pre-phased assemblies. Testing After Repair After any repair work has been carried out, the unit should be thoroughly tested to ensure that its operates correctly. This is especially important if the Logic/RF assembly is replaced. For general repairs which do not include replacing the Logic/RF assembly, simply placing a call and checking signal strength, and transmit and receive audio quality is normally sufÞcient. When the Logic/RF assembly is replaced, the unit must have a comprehensive test on a GSM compatible communications analyzers. See ÒTestingÓ on page 13 for further details. Placing a call on air is usually carried out at this stage to complete the testing procedure. 68P09392A89 27 Troubleshooting The troubleshooting information in Table 6, Table 7, and Table 8 shows some typical malfunction symptoms and the corresponding veriÞcation and repair procedures. Additionally, the ÒTroubleshooting SupplementsÓ are offered to assist in corrective action of more detailed symptoms. Refer to the disassembly instructions located in ÒDisassemblyÓ on page 21 for instructions on removing and replacing parts/assemblies from the personal telephone. If the Logic/RF assembly is replaced a personality transfer will be necessary. See ÒPersonality TransferÓ on page 17.
Related documents