Download EtherTRAK

Transcript
ET-8INS-U
ET-8INS
Overview
Instrumentation Analog Input Module
Eight configurable inputs provide 16 bit high resolution analog measurements. More information
can be found in the on-line help supplied with the SIXNET I/O Tool Kit program.
Number of Channels
Input Range
Input Impedance (current)
Input Impedance (other ranges)
ET-8INS
Wiring
4-20 mA Input
Jumpers
8 (16 bit resolution)
0/4 - 20 mA, 62 mV to 10V, JKERTBCNS thermocouples
100 ohms Note: input voltage drop = 2 volts at 20 mA
200K Ohms
Two input terminals are provided for each measurement channel. Channel to channel isolation is
provided.
This module has a 4-20 mA input enable jumper for each channel. Set each jumper to match
the desired input as shown in the diagram below. The jumper setting must match the range
selection in the SIXNET I/O Tool Kit.
Current
Shunts
Precision 100 ohm current shunts, beneath the hinged access door in the wiring base, pass
current and maintain loop integrity even if the module is unplugged. A spare shunt is provided
and may be simply inserted in place of any shunt that open-circuits as a result of a current
overload.
I/O Registers
Function
Analog Inputs
Section 7
SIXNET Registers
AX0 – AX7
Analog Input Modules
Modbus Registers
30001 – 30008
17